Open the battery compartment on the unit’s back side and insert 3 x alkaline LR6/AA batteries. before it goes out and begins normal functioning again.ġ. The indicator on the front of the unit is lit for approximately 4 sec. Insert 2 x alkaline LR6/AA batteries in the transmitter (making sure all the batteries are correctly insertedĪccording to the markings in the battery compartment). The wind direction sensor’s placement must be adjusted so that the direction corresponds to actuality, otherwise the readings will not be accurate. On the wind direction sensor’s edge are the letters N, E, S and W which stand for the four directions (north,Įast, south, and west). The rain sensor’s cable is connected to the input marked Rain on the thermo-hygrosensor (see fig.The wind direction sensor’s cable is connected to the input marked Wind on the thermo-hygrosensor.The wind gauge’s cable is connected to the input on the wind direction sensor.If the screen is not touched for 30 seconds it automatically returns to the normal display. When depressed the display gives off an audible signal and the background light comes on. The Symbols “+”, “ON/OFF” or “–” are used to input your desired selections. Using the weather station’s basic functionsĪll the weather station’s functions are controlled by pressing lightly on the touch screen display. Note: the alarm icon is shown on the display when the alarm is activated. The following instructions refer toĭisplay: Time, alarm, date and memory used. The display is divided into different sections according to the figure below. Transmitter (thermo-hygrosensor) including protective cap Operates on four LR6/AA batteries 5xbatteries type AA/LR6 (not included).
#Start easyweather data over software
Includes USB cable and software for statistics and analysis (Requires Windows 000 or later). Wireless transfer of data from five different sensors to an indoor receiver.ĭisplay of indoor and outdoor temperature, wind speed, wind direction, humidity, barometric pressure,īarometric pressure history, rainfall amounts, time and date. Wireless weather station with touch screen. The wrong polarity (+/–) can damage the weather station.ĭamage that has occurred by careless handling is not covered by the guarantee. Remember to always insert the batteries according to the markings in the battery compartment. Remove the batteries if the weather station is not to be used for a long time. Please contact our Customer Service Department (see address on reverse).ĭo not expose the main unit to rain or moisture. If you have any questions concerning technical problems
Or photo errors and any changes of technical data.
#Start easyweather data over manual
Please read the entire instruction manual before using and save it for future use.
0 kommentar(er)
